THE RC DRILLING PROCESS
RC Drilling penetrating uses somewhat joined to a down-gap mallet to create a gap. Not at all like precious stone penetrating, RC boring produces tests of shake cuttings as opposed to an example of shake center. The down-gap mallet is fueled by compacted air, which additionally goes about as the medium bringing the drill cuttings up to surface.
The compacted air (infused by the wind current swivel 1/goes through the external assembly of the drill bar (between the external distance across of the inward. tube and the internal width of the outside pole, blue bolt) to the down the gap hammer 2/where it drives all over a cylinder between two chambers. The air is emptied through valves which are opened and shut contingent upon the removal of the cylinder with a cycle of up to 2000 developments for each moment. Toward the finish of its course the cylinder comes into contact with the apparatus and the vitality transmitted to the device 3/is adequate to break the stone. The stone example once broken is gotten back to «cuttings» and streams up by the internal piece of the double pipe (through the inward cylinder, green bolt) by the impact of the weight of the infused air.